cliokhunt said:If you broke with the same pressure in the same situation with the same conditions in a non-ABS car the wheels would lock up
Ollie1982 said:Yes yes, i hear you chant, traction control may give you a little lee way in your FF 182's but its not a miracle worker.
cliokhunt said:This is a bit of an iffy point.
I agree on the place you're coming from about the absolute maximum braking force that the car can put down. But if the tyres are slipping, then they are loosing out on either acceleration or braking.
Sure when accelerating from a standstill you need the tyres to slip to keep engine speeds high, unless you fancy slipping the clutch (I'd rather take the 0.1 second penalty to 60 though).
Put it this way, the rear wheels are moving at a constant speed, let's say 100mph. The fronts are moving at 85 mph, something has to give because that's not possible.
They are both connected to the same chassis, albeit the rears aren't receiving power (I assume we're still talking about Clios) and are barely braking.
So then let's assume that for every second the wheels are turning, the rears are moving at a consistant speed, where the fronts are moving at 100mph on the surface for 0.85 of the second, but are locked for the other part of the second. I think you are describing ABS
So obviously the fronts moving 15% slower than the rears will slow quicker than if they were moving 100% slower (i.e. locked), but slower than if they were on the threashold of moving slower, i.e. not moving slower, but braking as hard as they can without starting to jump the road.
MarkCup said:Not once have I personally ever said that I could hold said braking forces through all conditions, nor would it be possible for anyone to do so on the road as the weight transfer would cause almost instant oversteer if any steering input is applied while threshold braking.
I accept that ABS is far safer for the majority of drivers.
I accept that ABS enables people to maintain steering control while mashing the middle pedal.
I accept that ABS is far safer in the majority of conditions.
I accept that ABS is far safer over the majority of surfaces.
What I don't accept (because it's not true ) is that a car equipped with ABS will stop quicker than one without. That's all I'm saying. And from your post above you don't disagree. Thank you.
What part of your mildly abusive post was aimed at me then?
MarkCup said:...I accept that ABS is far safer for the majority of drivers....
Stunzz said:If it's raining, snowing or icy I drive slower, leave a greater distance between me and the car in front and presume everyone else is a blithering idot.
Steve2004 said:ABS kicks in and I don't lock up... what's your point? :rasp:
Roy Munson said:As for using winter wheels to save ones alloys, well IMO if they cant stand a bit of snow and ice then they cant be very good alloys, but to each his own
cliokhunt said:Any wheels will corrode with a few coats of road salt and no washing. And I'm sure the people with £10000 a piece alloys will be licking them clean of brake dust and dirt every time they stop anyway !!
Roy Munson said:Most alloys are painted though, just like the car? Winter car?
cliokhunt said:I have never seen metallic wheels:dead:
It's lazy either way, whether it's because you don't know how to change a tyre or because you don't want them to get dirty. Gay.