Door removal

[Clart]

swapping my dented door with a good one tomorrow, am i right in thinking its 1 torx bit for the strap, then 1 pin top and bottom? Is it as easy as i sounds?

 

[Gaz_]

Yup. Undo the check strap, unclip the loom harness (the black clip pushes up, then the plug pulls out). Remove the clips on the pins and knock out. Have someone to hold the door though!

 

[Clart]

so i changed the door, not too bad a job tbh. is there anyway to adjust how it hangs, as its fairly close to catching on the fron wing when opening.

 

[Gaz_]

No adjustment in the hinges as far as i know. You can adjust how it sits when closed on the strike pin if need be

 

[Clart]

strike pin?

 

[Gaz_]

What the latch locks onto when the door closes . This only adjusts how it sits when shut though

 

[Clart]

so how do i adjust it? the gap between the door and wing is too small when its closed.

 

[Gaz_]

I dont think you can adjust the gap from the door to front wing....... The latch pin can be adjusted for how the door sits when shut to the rear quarter...