ECU CLio 172 ph2 Wiring PIN OUT

[prodriv3r84]

Hi Guy any one have the Clio 172 ph2 ECU pin out diagram?

Thanks

 

[JamesBryan]

Clio 182 Upgraded CPS Loom (Wiring Diagrams - ECU Pinout)

Hi All, Got an issue with my 182 i'm trying to trace, does anyone have a Pinout ECU diagram or Engine Wiring Diagram (would be handy for another job i need to do). Where do the 182 CPS wires go?? would rather test them before pulling the loom apart. do they go straight to ECU if so which...

www.cliosport.net

 

[prodriv3r84]

Clio 182 Upgraded CPS Loom (Wiring Diagrams - ECU Pinout)

Hi All, Got an issue with my 182 i'm trying to trace, does anyone have a Pinout ECU diagram or Engine Wiring Diagram (would be handy for another job i need to do). Where do the 182 CPS wires go?? would rather test them before pulling the loom apart. do they go straight to ECU if so which...

www.cliosport.net

Thanks a Lot.

 

[JamesBryan]

Thanks a Lot.

Even though it says 182 it should still be relevant for your 172.

 

[prodriv3r84]

Thanks I'm have a strange problem with the engine start, I need to check ECU that can be related with that.
Ignition KEY on and cranks for 2 3 turns and then stops dead, if i put the ignition on and wait a few secs before trying to start it will not crank, again, light will not go out. Imo light its off.

 

[c6mby]

Thanks I'm have a strange problem with the engine start, I need to check ECU that can be related with that.
Ignition KEY on and cranks for 2 3 turns and then stops dead, if i put the ignition on and wait a few secs before trying to start it will not crank, again, light will not go out. Imo light its off.

have you tried the transponder in the key?

 

[prodriv3r84]

Thanks for your replay. What do you mean with the transporter? I have disassembled the ingnition switch. To check out. But no conclusion.

 

[Rystar]

I have had the light staying on issue before. There is a small earth ring terminal for the ECU (8mm or 10mm bolt? i can't exactly remember) which can snap off with age. It is located near the left hand side drive shaft cup on the gearbox. Make sure this is attached, this gave me the same issue. However i am sure there is more than one possible cause I thought i'd mention it anyways.

 

[prodriv3r84]

I have had the light staying on issue before. There is a small earth ring terminal for the ECU (8mm or 10mm bolt? i can't exactly remember) which can snap off with age. It is located near the left hand side drive shaft cup on the gearbox. Make sure this is attached, this gave me the same issue. However i am sure there is more than one possible cause I thought i'd mention it anyways.

Thank you very much! I will take a look.