Fitting Mesh

[midget]

Hello there everyone im new to this forum and i have a question. I have brought some mesh and i was planning to fit to the front of my clio in grill area between my front fogs ( i have a clio mrk1 ) but i cant find a way to fit it with out destroying my bumper or having vibrating anyone had a simiar probs or any bright ideas

http://mysite.freeserve.com/blabobbla/images/0-picture.gif?0

MiDgEt

 

[Nick Read]

If I were doing it, Id break out the jigsaw, chop out that whole horizontal bar and then also take out all the plastic up to the front surface of the bumper. Then cut your mesh to size, about an inch bigger than the hole all the way round. Use no more nails to build up a flat surface to bond the mesh to on the back surface of the bumper, then either more no more nails or hot glue gun. Glue gun is a lot easier to work with and dries straight away.