I'll get some pictures today, I checked up on Spring and damper part numbers, appeared to be correct for car. Fitted complete new top mount setup apart from the metal spacer that goes between top donut and the bearingWrong dampers? Spring not seated correctly?
If you have new rubber top mount nut should be very low.
Any pics?
Original spacer and thin 17mm nut, parts were from GSFWhere were the dampers and springs from?
So you used the original metal spacer and thin 17mm nut? That's correct by the way, I've found the new stuff doesn't fit and you have to buy the silly expensive separate bolt.
Just about, been manic recently. Just bought another Clio too. How you keeping?Your still alive???
I'll get something on the go in the next week or twoBored as fk with no meets.
Might be a tad low. I put it down to weight of towbarI also think the rear looks to low too??!
I'll dig about under it a bit tomorrowWouldn't do that, but if the rear is dropping it'll make the front look higher. Front height doesn't look so bad over standard to be honest. But the top mount shouldn't be thy high