H&R help....

[PYE21]

Fitted the coilovers today, fronts when on fine and are fine at the moment.

However, i have the rears set as low as they will go but they a riding higher than it was on eibach pro's by 10mm. I can't see any other way to change the way i have assembled everything, yet it doesn't look right?????. Anybody got any ideas??

Pic of how it is now.

 

[Mike@Rentech]

fiited wrong, take the rubber off that the old spring sat into.
Push the adjuster in the hole in the axle and put the nut on the bottom.

 

[Mike@Rentech]

should look like this.... mine have been set a bit lower than this now.

 

[PYE21]

What happens to the other 50mm nut then?

 

[Mike@Rentech]

50mm nut locks the top part to the axle so it dont fall off.
Dont have a piccy of it from below.

 

[PYE21]

Cheers, i will sort it tomorrow.

 

[Mike@Rentech]

no probs fella

 

[Big Iain]

fuckin ell mate I wouldnt have driven it like that!!

 

[Andy_J]

me either.. well dodgy..

ping... pong... smash... "what was that?" eh that looked like your spring going thru the windscreen on the car behind!

 

[Adamhodg]

Bloody hell, im glad you came on here and asked for advice and didnt just drive it!. That looks damn dangerous!

 

[Dan_cup]

this is how mine is set mate

 

[PYE21]

All sorted now cheers for the help.

Ian

 

[eo52vug]

this is how mine is set mate

Thats how mine are set !

 

[Dan_cup]

this is how mine is set mate

Thats how mine are set !

good stuff, i originally had both nuts under the beam but couldnt work out how they would adjust, did sit lower though