JMS RS2 inlet installation help on Clio 172 cup

[bloke]

not as good as a standard manifold that's for sure. never done a back to back test though but they just don't gove good results and seen them on a few different models as well.

 

[1985michael182]

Must be better than the standard 172 manifold?

 

[bloke]

got to say pass on that sorry but if you're going through the hassle of fitting a 182 manifold you might as well fit a genuine one.

 

[1985michael182]

Hmmm might have to get the PMS one on in the near future then

 

[1985michael182]

So it was pretty straight forward but definatly needs mapping. Feels very flat pre 5000rpm

 

[barnesautos]

So it was pretty straight forward but definatly needs mapping. Feels very flat pre 5000rpm

Hope you don't suck in the black tape and cough at 7000rpm [emoji12]

 

[1985michael182]

Iv 4 layers of gorilla tape over those 2 holes before the black tape so it's not going anywhere. There's no pressure on them when the TB is open. But I get what you mean. Just a test fit really, but it all runs ok no dramas so ill make 2 ali plates to bond on and rip the carbon canister and acoustic valve out then clean the bay up and finish things off

 

[1985michael182]

Anyone got any preference on catch thanks? Need an AN10 90° fitting then some pipe running to A catch tank and then that's the hardware in place

 

[bloke]

Just don't use one of the cheap eBay ones, they leak out the bottom where they join.

 

[barnesautos]

If funds allow
Mocal gets my vote

 

[1985michael182]

So not like this which is bolted together

 

[1985michael182]

More like this, proper tug welded no seames

 

[barnesautos]

https://www.merlinmotorsport.co.uk/...Tu8eibXUutm7IZnf63P4lVJckCjWHYuBoCHJwQAvD_BwE

 

[1985michael182]

I ment tig welded

 

[1985michael182]

OBP it is they look alot better engineered. Why 3 outlets though? One in, one with a breather filter, 3rd one?

 

[gambit]

So it was pretty straight forward but definatly needs mapping. Feels very flat pre 5000rpm

Well done, did you do an install guide ?

 

[1985michael182]

Not as yet. It all needs to come back off to properly block the 2 holes drilled into the plenum so I'll take a load of pictures and do a little write up. Took an hour too fit including the pms coil relocation plate and the pms breather plate. Pretty straight forward.

 

[1985michael182]

Also going to 're laquer the carbon to freshen it up

 

[1985michael182]

Gambit have you got this inlet aswell?

 

[1985michael182]

So who is recommended for mapping?
Postcode area yo17 6tb

 

[imprezaworks]

Efi Runcorn