Looking at building a 1.6 16v K4m engine for use in single venue rallying.
I'm looking to go down the route of the following:
Head skimmed
Head ported and polished
An inlet plenum
New valve seats cut and ground
New valves
A set of CAMs unsure as to which ones yet
And a REMAP if this can be done
Anyone with any advice or anyone been down this route before??
I'm looking to go down the route of the following:
Head skimmed
Head ported and polished
An inlet plenum
New valve seats cut and ground
New valves
A set of CAMs unsure as to which ones yet
And a REMAP if this can be done
Anyone with any advice or anyone been down this route before??
