Ktec studs

[tobeski]

Is there any significant difference with the Ktec and Pure Motorsport stud conversion kits

http://www.k-tecracing.com/show_product.asp?id=4784

I appreciate these step down to 1.25 rather than staying 1.5 but I don't see that being a major issue. If anything the fine thread could help prevent shearing.

Both are 10.9 tensile and bullet head design to stop cross threading.

Ktec ones are nearly £50 cheaper???

 

[Martin.]

I noticed these too.

Think they come in two different lengths too so maybe the shorter studs will allow for some locking nuts.

 

[Chip-mk1]

1.25 thread is probably better for preventing loosening if anything.

Not used them, but they look good.

 

[Tony Hunter]

That is very reasonable, I've just paid £120 for mine.

 

[tobeski]

I think I'm going to go for these then instead of the pm ones.

 

[EVOgone]

Look like the Techno2 ones Walkers garage sell, they sell them in 83mm and are perfect length for 10/20mm spacers. Great service and next day delivery.

http://www.walkers-garage.co.uk/shop/contents/en-uk/d31.html