Liquid yellow 182
Done a lot of searching already but obviously a very common problem with lots of potential causes.
If i could get some feedback on the comments below that would be great.
Had emissions light come on solid periodically. But it goes off so had ignored it.
Misfire started gradually e.g. on motorway slight hesitation.
Changed coil pack to £30 ebay special. seemed OK
Developed into full blown misfire. Flashing emissions light. Towed home by RAC. Fault code lambda bank 1 sensor 1.
Changed plugs - found cylinder 1 plug well, and spark plug covered in oil from spill while topping up.
Changed leads to magnecor blue.
Misfire went away on idle, but came straight back when up to temp
Changed Lambda sensor.
Checked plugs - still slight oil residue on new no. 1 plug. Cleaned it off.
Misfire went away at idle, and on 15 min test drive. Next day moving the car around misfire came back.
Checked plugs no oil residue.
Cleaned throttle body and inside manifold. Fair bit of oil / gunge in there.
Cleaned MAP sensor, Cleaned plenum sensor (temp??) used brake cleaner... probably fucked MAP up more?
Plugging and unplugging MAP sensor doesn't seem to make a difference... what SHOULD happen if you do??
Haven't checked injectors - do i need special tool?
Where is TDC sensor??
Will the missfire kill my new lambda and coil pack?
How sensitive is the car to proper NGK spark plugs - I just put in the reccomended Bosch plugs from eurocarparts.
I've dropped the oil and filters while we're at it too. but can't see how this would have an effect.
Thanks for reading this far!
If i could get some feedback on the comments below that would be great.
Had emissions light come on solid periodically. But it goes off so had ignored it.
Misfire started gradually e.g. on motorway slight hesitation.
Changed coil pack to £30 ebay special. seemed OK
Developed into full blown misfire. Flashing emissions light. Towed home by RAC. Fault code lambda bank 1 sensor 1.
Changed plugs - found cylinder 1 plug well, and spark plug covered in oil from spill while topping up.
Changed leads to magnecor blue.
Misfire went away on idle, but came straight back when up to temp
Changed Lambda sensor.
Checked plugs - still slight oil residue on new no. 1 plug. Cleaned it off.
Misfire went away at idle, and on 15 min test drive. Next day moving the car around misfire came back.
Checked plugs no oil residue.
Cleaned throttle body and inside manifold. Fair bit of oil / gunge in there.
Cleaned MAP sensor, Cleaned plenum sensor (temp??) used brake cleaner... probably fucked MAP up more?
Plugging and unplugging MAP sensor doesn't seem to make a difference... what SHOULD happen if you do??
Haven't checked injectors - do i need special tool?
Where is TDC sensor??
Will the missfire kill my new lambda and coil pack?
How sensitive is the car to proper NGK spark plugs - I just put in the reccomended Bosch plugs from eurocarparts.
I've dropped the oil and filters while we're at it too. but can't see how this would have an effect.
Thanks for reading this far!