Ph2 rear bumper on a PH1 HELP!

[Liam@redmonkey]

Any advice on fitting this would be great!

 

[DannoTheGreat]

undo the bolts of old bumper, take off.
put new bumper on tighten bolts

 

[Liam@redmonkey]

I didnt think it was a direct swap???

 

[Tupps]

What Danno said

 

[Liam@redmonkey]

So no drilling just swap??? you promise?? LOL

 

[Liam@redmonkey]

?????????

 

[Darren85]

Correct this is a direct swap, no other faffing about required.. Promise :rasp:

 

[MarcoB]

You do need to do some drilling with non rs bumpers onto non rs. I wouldnt know about RSs though

 

[Sean6545]

Early ph1's the bolts along the top of the bumper dont line up. And the offside arch liner no longer fits right.

 

[Ian]

Yeah the non-RS bumpers are a right pain to swap, but as above, the RS bumpers should be a straight swap afaik.

 

[mikey123]

straight swap for the 10th time!

 

[MarkEvanson]

arghhh mines not lining up its got 4 holes in the ph1 but ph2 has 2 :S

 

[Tony Hunter]

Its only plastic,drill it.

 

[Jimbo-Clio]

just dnt do it PH1 is a PH1

if you still feel the need to do it

should be straight swap if your worried about excessive bolt holes not being used eiter tape them off or drill and fit a self tapper there but from the ones i have seen done its on and off job