Pics of the rear disk spacer?

[Skeeter]

Has anyone got any pics of the rear disk spacer? Either fitted or just loose, just so I know what they look like.

 

[LiamR172]

Its a bit bigger than a 10 pence coin and is flat on one side and the other side is shaped. Almost like this |)

Iirc the flat side goes against the stub axle.

Sorry i dont have a pic

 

[DannyR]

Its a bit bigger than a 10 pence coin and is flat on one side and the other side is shaped. Almost like this |)

Iirc the flat side goes against the stub axle.

Sorry i dont have a pic

It's a lot bigger than a 10p coin.

 

[LiamR172]

Sorry. Been over 2 years since i done mine. Did i get the sides the right way around?

 

[Steven103]

I'd describe it more like |( ????

Conical side goes up against the hub (if you look really closely there's a small radius where the stub axle appears to "meet" (it actually goes through IIRC for obvious reasons) the hub. The conical face goes is there so the spacer doesn't foul the radius)

http://www.cliosport.net/forum/show...disks-is-this-the-spacer&highlight=6000073518

 

[LiamR172]

Dick.

 

[Skeeter]

Cheers guys.

Confirms that I am indeed missing them on both sides! 8 track days and 30k road miles and my wheels haven't fallen off though, so clearly not the major issue people think they are!

I will need to grab some, and also some replacement 30mm hub nuts. Where is best to get them from?

 

[DannyR]

Cheers guys.

Confirms that I am indeed missing them on both sides! 8 track days and 30k road miles and my wheels haven't fallen off though, so clearly not the major issue people think they are!

I will need to grab some, and also some replacement 30mm hub nuts. Where is best to get them from?

You've been lucky. I had to replace a bearing before a track day after I'd replaced it the weekend before and forgot the spacer!

 

[Tommo.]

I will need to grab some, and also some replacement 30mm hub nuts. Where is best to get them from?

Adam/Renault Wolverhampton or @G 172

 

[George@RTR_Parts]

^ ta mate

Yep got both genuine spacers and rear hub nuts on shelf if you need any OP just PM me

 

[skydiver]

 

[LiamR172]

When i fitted my disks and bearings without the spacer my wheel wobbled quite badly. I blamed it on a dodgey bearing so sent it back and got a new one. Obviously the new one was the same. Then i found out about these things

 

[Skeeter]

I've clearly been very lucky!

G172, PM inbound.