raising lowered suspention

[Clio16vPaul]

Ive decided i need to raise the suspention a little on the rear after the kwik fit nightmare...

Its a peice of piss to do, i took the torque bars out last night and raised it by about 15mm - need to go a little further now, can the suspention be lifted by whatever you want or does it have to be in certain increments?? im looking to go up another 15mm maybe just to clear the exhaust from the ground

 

[aaronc]

Make sure its level as this can be difficult to achieve.

 

[Clio16vPaul]

I found it easy to remove the torque rods, hard to get them back in, but by measuring the didtance from the ground to the base of the disk it was easy to set both sides level, maybe i was just lucky??