Replaceing the Interior

[VIICarCare]

I'm looking to swap Interior in the 1.2, door cards etc. Do the rear cards just pop off?

Cheers

 

[clancy]

you have to undo the seat belt mount that goes through it, then pop off all the clips around the edge. the ones along by the top by the glass go up and the the ones by the doorjam go towards the front of the car if that makes sense ?

then it will be loose but the front seat belt mount will be stopping it, youll need to undo the black thing thats below the B pillar, like a thin black tube with a disc on the end ?
it has the one visable torx bolt you can see and the other end just sits in place behind the door card, youll have to fiddle with it to get it off

think that makes sense lol, sounds harder than it is, just the last seat belt mount thats abit fiddly

 

[jesus]

There is also a LOT of sticky s**t that goes around the sides and bottom of the door card that you'll have to go round with a knife to cut it off.

 

[VIICarCare]

hmm, cheers for your help boys. I'll have a go now! If I get bored I'll get back to the waxing!

 

[VIICarCare]

Grrr! The rear seat back, I see where the rollers on both side goes in & I see two bolts at the rear. Do I need to get these bolts out to remove the seat back? Only trouble is the bolts are seized!

 

[clancy]

you need to remove the black bar in the boot behind the seats, its held on by two big gold bolts, 17mm i think. they are an absolute t**t to get off. impact gun is your best bet or a big breaker. once that bars off youll soo two torx bolts in the floor where the rear seats join; only one of them needs to be undone and then the plate can slide out from under the other bolt. once you get the black bar off youll see what i mean