rs2 quiry

[Mack182]

i recently fitted my RS2 Xtra and have fitted the anodised plate to the rocker cover to hold the coil pack, so was wondering does little hole on the rocker cover need to covered or blocked as this is normally covered by the inlets ?

cheers

 

[Mack182]

It's the little weep hole ? No one have any ideas ??

 

[mi16chris]

Small breather filter would be best on it mate , it's a engine breather just

 

[mattypy282]

It's the little weep hole ? No one have any ideas ??

If its the 1 im thinking of its the size of a pin prick

 

[Mack182]

If its the 1 im thinking of its the size of a pin prick

Yer that's the one, on top of the engine

 

[mattypy282]

I was also wondering pal. Never seen anything on pictures

 

[Chip-mk1]

Just fill it with a tiny bit of silicon so it doesnt weep, its not required.

 

[Mack182]

Just fill it with a tiny bit of silicon so it doesnt weep, its not required.

cheers chip ill give that a try.

 

[ozclio03]

is this pin sized hole on the 182 also?

 

[MG cup]

Yes just next to the oval part on the breather plate, you will only see it with inlet off.