spacers for turbines

[domsclio182]

Just fitted some turbines to my 182 and think they could do with some spacers,just wondering what size people tend to go for,was thinking 15 or 20mm H&R'S.

Just want them to sit in the arches nicely not stick out or anything.

 

[ScarySquirrel]

You need to measure the gap between the inside of the arch and the widest part of the top of the wheel. So if it's a 15mm gap, you'd probably be best off with 10mm spacers.

 

[LewisTaylor]

I've got 15mm h&r's on my rears and they are very good. Want to ditch the front delta mic's for a set of these at some point.

 

[Rhys Beal]

Depending on how much camber you are running on the front, I would go for 15 or 20mm up front and 10mm rear on those Dom

 

[dmallett]

I have 15mm and 25mm you can try on your car if you want to tomorrow?

 

[domsclio182]

Are you selling them then mate what sort are they,are they hub centric ones.

 

[dmallett]

Im not selling, but you can try them on your car lol

But i do know my mate has some 15mm delta mics he wants shot of!

 

[domsclio182]

Ok mate not to worry but thanks for the offer, going to get the H&rs had a good measure up today and going to use 15mm on the rears and 20mm on the front.

 

[dmallett]

No worries. My 15mm spacers rub on the rear on 195/50/15, dunno how low yours is in comparison.

 

[Rhys Beal]

I think your Willy wheels Dan are a wider offset than the Turbines but I maybe wrong

 

[Ben626]

Sorry dint mean to post on this thread fudgin phone
Edited.

 

[dmallett]

I think your Willy wheels Dan are a wider offset than the Turbines but I maybe wrong

ET 36 I think.