Splitter help!! :(

[Simon_172]

hey all
i just did a oil change and was taking my car off the ramps and it pulled one side of my splitter off... what are the screws called i need to get and were do i get them from??

thanks
si

 

[Spark]

self tapping screws from any hardware store

 

[Simon_172]

cool thanks dude.

 

[hazzel_frazzel]

Right I tried this with self tapping screws from homebase, with a screwdriver by hand, and no way were those screws getting through. Then tried with a drill at low speed and a screw bit, still not working, and even tried higher speeds on the drill, these screws will not go in! any ideas?

 

[graham_172]

pre drill the hole first. use a 1-2mm drill bit

 

[Hazza]

Make the screw hole smaller than the actual screw itself, (but obviously not too small that it won't go into it)

That should keep it tighter.

 

[ben24]

some people !

 

[Simon_172]

i have used no more nails for now and it bloody strong stuff lol. it is only a little bit on the edge so i may just leave it see how it goes just glad its not hanging low now