Timing out????

[bravoking1]

Hey guys I have a clio 182 and I have been on a dyno today and with a forge silicone intake hose rstuner remap and k&n panel filter and custom exhaust my car is only creating 155bhp it runs ok but it had a timing belt before I purchased it and was wondering if my timing could be slightly out the only other fault is the diphaser pulley is slightly noisy but you have to have the bonnet up to hear that thanks guys

 

[Mr R.]

Could be or could just be the rolling road that you used.

I did my belts on my ph1 and it made 171.8 bhp on TDF rollers. (just ITG filter)

 

[Chip-mk1]

Hey guys I have a clio 182 and I have been on a dyno today and with a forge silicone intake hose rstuner remap and k&n panel filter and custom exhaust my car is only creating 155bhp it runs ok but it had a timing belt before I purchased it and was wondering if my timing could be slightly out the only other fault is the diphaser pulley is slightly noisy but you have to have the bonnet up to hear that thanks guys

Does it run different with the dephasor solenoid disconnected?

If its not working that would also cause a big drop.

Failing that though, timing is certainly likely to give that sort of drop if its out by a fair margin.

 

[bravoking1]

I don't think it was the rolling road as I know the guy that owns it and know it works fine might have to have a look at the timing then

 

[bravoking1]

Will have to try disconnecting the dephaser In a mo

 

[MartinR]

155bhp at the wheels? if so its about right.

 

[bravoking1]

Yeah 155 at the wheels in 4th gear wasn't sure especially with the mods lol cheers mate

 

[bravoking1]

Although it should have translated it into engine power

 

[bravoking1]

Although it should have translated it to flywheel power

 

[MartinR]

That figure is good it equates to around 178bhp at the fly.

 

[Chip-mk1]

Post the graph

 

[bravoking1]

This was the best run