What have you done to your car today ???

[jonnys inferno]

Gave her a wash down, still passes the 10 foot test

In other news, Halfords own tar remover is rubbish!

 

[OssPoop]

Polished passenger headlamp, 2 weeks after i did the other one! Had to wash her after too.

 

[Chris V6 255]

Fitted an AUX lead in the GTI.
Was a mission to get the stereo out!

Sent from my iPhone using Tapatalk

 

[sharkaroo]

Replaced my engine mounts

 

[Ills]

Refitted the cat for the MOT next weekend (decat is for sale btw), new pre cat lambda and adjusted the handbrake- now holds on hills which is useful!

 

[STEVE.M]

One corner done. Nobody said getting it out and back in was a puzzle to put the krypton factor to shame!

That`s a brave place to put the axle stand.
If you have both wheels off the ground,you won`t have to fight with the anti roll bar.

 

[Mar172]

Replace the rear springs on the mec new spark plugs and brake fluid

 

[Mr R.]

Wired in a proper subaru rear fog light switch instead of the rubbish one they fit when the car is imported.

Had to buy a new panel from Subaru as they had drilled the one one to fit this junk.

 

[eon172]

Decat replaced with temp cat, MoT - passed after changing from crap osram dipped bulbs (because of poor light pattern) to lucas, also fixed horn wiring :-s ...top MoT'er very helpful!! Will now check exhaust dB levels with cat and with decat + straight through KTec centre section see how close to trackday and sprint reg limits it is.

 

[Jme34]

Just a few little bits. Fitted new thumb grips and went at the pedals with metal polish.
Just toying with the idea of paying to have this little dent removed before goodwood breakfast club... First time, first impressions and all that...

 

[cs_dave]

Lowered it

 

[16v-clio]

Tried to start it. Tried a cheap code reader on it. Cried a little.

 

[Daz...]

Picked it up from the garage after having a new front wheel bearing fitted. Apparently most of the old one fell out!

 

[Karlos182]

Tightened up my evol dog bone mount. I'd noticed that it wasn't as noticeable when driving, so I checked underneath and found that the rear bolt had worked itself loose. Tightened it up now and hoping it won't work loose again.

 

[Jme34]

Fitted new front discs and pads, nowt special though, OEM spec brembo pads and HC brembo discs. ordered from RTR [emoji1303] braided lines are next on the list!

 

[imprezaworks]

Cleaned it, obvs.

 

[jonnys inferno]

I fixed my passenger seat as it wouldn't let people into the back seat. I thought worse case scenario is cable had snapped but luckily it had just stretched, it wouldn't pull the cam up so I bodged it permanently. One chocolate block connecter over the end of the cable, do the screws up and now my chair works!

 

[cs_dave]

Loaded one up for its death as it tried to kill me.

 

[Paris 182]

Nothing on the car but i did a folder for all my service history paper work and all the mot certificates.

 

[letsturboit]

Hovered my finger over buying a 182 manifold and cat to replace the pikey decat I had done...

Still unsure on the 182 Mani...
Extra performance.. Maybe.
Extra cost... Definitely
Anyone done it with proven gains.?

 

[cs_dave]

Hovered my finger over buying a 182 manifold and cat to replace the pikey decat I had done...

Still unsure on the 182 Mani...
Extra performance.. Maybe.
Extra cost... Definitely
Anyone done it with proven gains.?

Couple of bhp to gain

Sent from my SM-G920F using Tapatalk

 

[andrius7]

getin ready for MOT

no lights - no problem

 

[OssPoop]

Cleaned it, obvs.

When did it get dirty?

 

[imprezaworks]

On the way to work

 

[BGEarles]

On the way to work

Mine will be getting the works tomorrow, up bright an early [emoji594]


Sent from my iPhone using Tapatalk

 

[RSLDH]

RS192 exhaust ordered. Was really stuck on which one to go with nearly went with the pure motorsport but I really didn't like the tips! Never had a scorpion exhaust so thought I would give it a go.



Sent from my iPhone using Tapatalk

 

[kano]

Fitted a new K&N cone filter.

 

[MarkCup]

Not today but a week ago I did this...Clio 172/182 brakes are pretty much the same so should be just as easy to do. Thinking back I never did mine in 125k miles on my 172 Cup and I really should have given the abuse it took!

 

[Salesy1972]

Fitted my short shifter, brake pads all round, fluid change, oil and filter change, air filter and a good clean.

 

[clc0608]

Got her ready for the Goodwood Breakfast Club Hot Hatch Sunday meet. Last full detail until next summer, to help keep the most of all the crap winter is going to throw!

 

[Jme34]

Did my prep for going on show at Goodwood next week as well!
And by that I mean grinding the crap out of my wheel on a kerb [emoji35] last minute wheel refurb incoming!

 

[Salesy1972]

Did my prep for going on show at Goodwood next week as well!
And by that I mean grinding the crap out of my wheel on a kerb [emoji35] last minute wheel refurb incoming!

OUCH

 

[welshname]

Got one ready for sale.

And the other fixed this fault

 

[andrius7]

made my day faster :smile:

 

[Mr R.]

Made a start on lowering my van. [emoji41]

 

[OssPoop]

Filled her up, its getting expensive again. #robbingtwats

 

[Welsh.Dan]

Filled her up, its getting expensive again. #robbingtwats

Truck in work today [emoji4]

 

[Ex-User (72296)]

Fresh new windscreen and seals, so satisfying!

 

[The Russian.]

Cleaned it, it looks so so good when properly clean.

 

[Salesy1972]

View attachment 168172 View attachment 168173 made my day faster :smile:

Autosolo? Where about was this. I compete in Autosolos too but we are losing many venues due to noise restrictions