Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Earlier this year I had my car damaged by a delinquent OAP driver, smashing my front wing on what was a tidy ph1. I have removed the damaged one and fitted a 2nd hand replacement this weekend.
I have this bit of plastic trim left over from behind the bumper /under tray and cannot see where it...
My searches don't seem to be giving me a steer on my problem. Since the car came out of its winter storage I have had an issue with non-cold starts. When I say non cold I mean it will start first thing in the morning but if I try to start again say 9 hours later after being parked in a multi...
I managed to get a Bremi coil pack from ECP and a cheapo set of leads from GSF and it’s now firing on all four cylinders. At some point I will refit the old coil to see if it was the leads. Ready for its first track day of the year now.
It’s seems not only is my Clio not working neither is my multi meter, just been out to test and it’s not even showing the main battery voltage. I had tested the injectors by cranking when out against card board. Got four dots.
I am getting a misfire, my car has been in the parked in the garage since last August. Have a track day on Tuesday so thought I better get it out to check it over and it's misfiring. I have checked the following:
No water in plug wells
Spark plugs are correct NGK R all appeared OK and less...
I have fitted sportlines with cup dampeners. Very happy with the improvements, much flatter on the track, far less body roll and subtle drop . Needed camber bolts and two wheel alignments to get it set up right.
I have recently added fitted eibach sportline coils with renault cup dampeners. After that I had a wheel alignment done and could only get +0.25 degrees of camber. Fitted Eibach camber bolts and the realignment got it to 1.3 max. It feels much better, improved self centreing , less vague and...
I have done some searches and can't get an answer. Does my ph1 have a pollen filter?
I am servicing it next weekend and have peered under the bulkhead plastic trim and can't see one. It has manual air con.
Thanks.
Went to start the Clio this morning and it would not start without the red button being pressed on the inertia switch. I am going to replace the switch. It would appear they are a generic part but can't find any listed on the usual parts websites. anyone else replaced theirs??