Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
It's unfortunate that some homes are so far away from exchanges and as it's over BT infrastructure it'll more than likely be old and jelly crimped in a few places causing it too attenuate the signal.
Re crimping the cables to face plate and also checking the box at front of house unless if...
I haven't dan and I'm fairly new too this. From what I've read and you mentioned it's too do with spark total trim and running slightly lean.
Under the first start I can see stat sync'd is this the one?
Thanks
Looking through the MAP 3000 software and this is my spark total which I'm lead to believe is causing the car to get hotter quicker.
I've closed the throttle boddies up to 5kg/hr on each inlet an it does improve bit brings the idle down too low causing it too hunt.
Any tweek so can make...
Omex reads the Crank Position as well as the Renault when spliced into it (2 Wires).1. What is the use for the renault ECU connection? (Dash Data?)2. Is it needed?3. What are the implications?I have created my own standalone IGN CCT with the OMEX wired up to a custom fuse relay setup.So with the...
Omex reads the Crank Position as well as the Renault when spliced into it (2 Wires).1. What is the use for the renault ECU connection? (Dash Data?)2. Is it needed?3. What are the implicationsI have created my own standalone IGN CCT with the OMEX wired up to a custom fuse relay setup.So with the...
Remove top first
Then bottom will become evident.
Top
3 screws in vents
1 in sides by rubber door seal
3-4 screws behind the silver RS trim
Pull up and towards you too slide off
Bottom
You'll work it out ;)
Chip wrote this;
I tend to think of roughly (include weight of driver / passenger):
150bhp per tonne = ok for getting started on trackdays, but you'll get stuck behind people a lot and frustrated if your car handles well so you catch them in the bends but then cant get past them on the...
I'd also like to elaborate on what I just said......
Boosted for same price for more power on standard internals.
It would cost 6k to reach a low pressure standard. From start to finish
Oh and the itbs are prone to having to be balanced every now and then.
Hear someone say on here it's...