Clio Mk1 Valver Loom Project - ID these connectors!

Redoing an absolute mess off a loom thats full of bodges, trying to keep the bare minimum to remain road legal in a stripped out hillclimb car. The car now has fibreglass doors so I'm thinking the whole of the door looms can be deleted back to the next connector without issue? The plan would be to leave a small service loop and seal with heat wrap rather than remove the pin, in case I have to go back and use them. Will have loads of questions so appreciate any help. First connectors below:

I really wish I could help but you've just given me flashbacks to trying to fix the PLIP system on my Williams. Also, the loom wrapped around the two cupboard door knobs looks like a hippy on a super bummer trip, man.

If you can get me a little bit of what’s close by to those plugs on the loom I might be able to help.
They do look like decoder connections , if they are local to the interior fuse box that is.

Edit : I this I see the decoder in the last pic, so can’t be them then.

@Dannyafro @Renny 5 may be able to help

My R5 loom looks abit different. @Coops Mk1 do you what these are? Danny Afro might know aswell but he’s not that active on here

I don't know I'm afraid but I'll ask Tiny Looms Peter who's a wiring guru, you can also join the MK1 F4R Facebook group.


When I did my conversion I just chucked the entire loom set in, wired up all I needed and then just fired it up and started hacking plugs off. So I'm not really the best person to ask about a none bodge approach as I'm a self confessed bodger, flol

barnesautos said:

If you can get me a little bit of what’s close by to those plugs on the loom I might be able to help.
They do look like decoder connections , if they are local to the interior fuse box that is.

Edit : I this I see the decoder in the last pic, so can’t be them then.

Click to expand...

OK more Intel coming in:


The connectors and associated wiring are in my hand and they go to loom between the fuse box bit with the relays and the rest of the loom



Two of the wires go to the doors so have been cut and rolled back to be deleted.



Traced some other wires, one above goes to this relay box that didn't have a relay in. Any one know what it's for? One also traced to the relay next to it



Others go to random places like this. Will try draw it out. The masking tape is where it was cut from the OS door loom

Alarm system?