Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
a few more video's
http://www.youtube.com/watch?v=S_zH1YTTSMY - very wet!
http://www.youtube.com/watch?v=8X_htUfb1e0 - a short one as the camera stopped after a few laps.
had my car go into limp mode a few times near the end of the track day so today I plugged it in and found the throttle...
alrite guys
had my 2nd Knockhill day on Sunday there (26th January)
since my last update I have done a good few changes after fitting a new steering rack, bottom ball joints, track rod ends, rear shocks, drive shafts, I also put uprated top mounts on but I just wasn't happy with them...
the chances are that I have tbh... I have got the abs light off now. I have the steering angle sensor with the yellow light on an still get the traction and service light, after starting up and moving off they come back on. it has only disabled my traction control which I don't mind as I turn it...
i fitted a new wheel to my car and my angle sensor is out as it has all three lights on, how do i correct this?? wheel off put it straight and have the angle sensor in what position?? centre left right...
I have put a Sparco steering wheel on my clio and now I have a service light the traction control light and abs light on
i have put a diagnostic box on it and it cleared the abs light but the service and traction control light stays on
I've took the wheel back on and turned the (don't even...
I was only 19 or something when I had that astra.. had just fitted the cherry bomb haha! and its actually sitting with no springs in the rear in that picture, wasn't really that low :)
I'm making or planning on having a good handling car that does track day but it's not a track car.. (If that makes sense) I have already replaced steering rack track rod ends and bottom ball joints. And when I attempted to fit these coilovers I noticed my top mounts are a bit done so with will...
when wiring in the 3.3 or 3.9ohm resistor to remove the air bag light do I need two resistors and link out both plugs that did go into the air bag or.. do I just need one and link it from one plug to the other...
I'll have a look into cooksport springs and parts.
I was told they where K-tec coilovers, and that they came off a 04 clio 182 so just guessed that one 182 was as like the next..
Recently bought a set of coilovers for my clio but when going to fit them today the front struts did not line up...
Where the two bolts at the bottom of the coilovers join your hub etc did not line up..
What I need to know is why they don't fit, bought 2nd hand and was off a 2004 182.. Mine...
Small update:
what else better to do on a Sunday... In the rain.. And in the cold..
before picture.
The old splitter came of in three parts so well overdue needing replacing. A wee Fabia one now in its place.
and after:
Thanks lads, all comments welcome good and bad ha!
The MG is still up at Knockhill the boy I sold it to still takes it up for hot hatch day and it still goes really well .... Surprisingly for an old tarted up rover haha. Without going into detail, it's a honda civic really that can run...