Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
it doesn't have a trust power supply does it??
as my mums pc is doing the same and has only started doing it since i had to replace the tagan power supply.
if your trying to make a new board for the clock back light i'd try and go for wide angled 5mm leds
this would make building pcb easier as it is a pig to solder smt leds on to a strip board
something like this should work
are the clamps tight on to the battery ?
had a problem with my mums corsa the other week where it would jump start fine but not from the battery did a few checks and found that then neg at the batt wasn't a good connection so gave it a clean and tightened it up and it was perfect then
the lights that only really suffer from light scatter is ones that use the front of the headlight to direct the light (usually glass with the lines in them).
reflector ones will suffer slightly but nothing to be conserned about imho.
H4 lamps contain both the dipped and main in a single lamp...
is there any capacitors on the tweeters? As they are sometimes wired in series and would show as open circuit if it was. I'd just connect them to some thing and see if they work
yeah but do it every other day for like a week before getting a new one
people seem to think once a battery has gone flat you need a new one but you often don't
how you charging it?
if it's with the engine running i'd drive it for a least 30 mins (not just ticking over)
with a battery charger it could take up to 12 hours
you get 2 stylus things, a plectrum, headphones and the control part, a stand and a rubber case + the cables to connect it to your tv/pc.
yeah this is the first touch phone i've had but i'm pretty used to it already. although i tend to use the stylus due to being ham fisted lol.
the only thing...
iirc you should be able to swap the wires to get it to work all the time
you have to put both red and yellow into the red connector or something like that
if your looking at xenon effect lamps on ebay or anywhere else then don't lol
if you want uprated without going the H.I.D route stick to the big makes like Osram and Phillips