Search results

Yes if you want to start and stop the fan willy nilly then use that method. If you would like to have it on when you have the HU on, then off when your HU is of (you could still add a dead switch to control summer (hot days) and winter use). What normally is done is the remote cable is fed off...

Surely he could series the convertor into the original loom to the rears, as opposed to parallel them. Thus raising impedance, and puting less a strain on his HU. Ok, he will lose volume on his rears, and on his convertor, but volume loss in the rear wont be great, and his gains can make up for...

Yeh, good earth point too if you sand down the paint to metal. I run nearly 400amps through this earth point :P thats 2 runs of 4 guage going to each side.

Basically back EMF is an electronic force which gets inherent in any moving electric object through a magnetic field ( motors or dynamos). So as you spin the object upto speed inside the field, a force acts to stop the object infinatly accelerating. Like when you run fast your legs get knackered...

Back EMF's of the alternator (harder to turn basically). Along with other resistive forces. Basically for a given winding, the greater the current draw, the greater the back emf. So it's very much current draw dependant, however the additional weight of the windings to be a higher value (110...

Nah, i know a lad who does rotary elecs for a living, he said that 250a would lose me about 10bhp. The quoted me £200 for an alt and another 200 for fitting, i said jog on! :P. Not bothered about performance loss tbh.

Sweeet. Let me know if it fits. As basically i don't want to go out and pay £100 for a 110a alt to find it needs custom bracketry, whereas for £200 i could have had 200a alt as will still need custom bracketry!

Or will a 1.5 dci alt fit straight onto a 1.2 engine???

Mechanically speaking, will a 1.4 altenator fit DIRECTLY onto a 1.2 engine. Yes or no...

Standard speakers are a lot more like 10wrms mate!

If you read this Lee, i'm still running her strong for you! Apsolutly love this. Active setup with built in XO's!

Sorry, but you gotta be doing some pace to do that to the car! Look at the one pishing alloy above!^ In what looks like a built up area too! Tool.

Can we ban him for using the above word in the detailing section? Do a search for snow foam lance and snow foam. I got a cheap karcher lance from hellfrauds was about £10. Does the job though.

Yeh, wadding makes the sub think it's in a larger box (due to the compression of the air easier than compressing the wadding). However it also dampens the box, so you slightly lose a bit of DB on your peak (2db ish). Yet you easily gain that back from bottom end with the sub thinking it's a...

+1 Just tell him what you want and he'll sort you out.

Yup, this one then... http://caraudiosecurity.com/shop/product/products_id/6757.html Also soem have difficulties with full display use, whereas others have it run perfectly. Do a search, there's loads of info.

Please use the search function! If you have display on dash http://caraudiosecurity.com/shop/product/products_id/6913.html If you don't http://caraudiosecurity.com/shop/product/products_id/6914.html Then pioneer side of cable: http://caraudiosecurity.com/shop/product/products_id/8653.html £40...

As you can see. 2 massive batteries (35kg each) 1 Huge sub (31kg) A load of box (~5kg) And still i have it bolted 8 times over into the floor mate!!! I'd give it a miss thanks if that was coming towards me when the car decides to roll its way in a side collision on a country lane, thanks anyway.

On the insulation? No. If you break the wire or severly damage the insulation then you have a problem :P.

Make sure the misses is on that tea you ordered!

Middle of door card is definatly glued on, but onto legs so to speak, so when you yank, unless you yank square, it will never sit back clean again!

As haynes manual..... Back of HU on loom, LH front (can't give you polarity sorry) : Beige and pink RH front (polarity again, don't know, sorry) : Green and brown These are also the colours that go to both the mids and tweeters too. So the cable colour doesn't change basically. Apart from the...

On a 3 door, very hard, says haynes manual, due to them being sealed in mate. Dodgy adhesives and everything apparantly! Apparantly though you can get the new bonding compound from renault. Or bodge it with silicone :P.

Open boot. Top right corner, i believe, on the plastic is a single small sized torx screw, remove that and carefully remove the plastic from clicky things (like those in a door card). I just ran my hand around the edge once i had removed my screw, then just eased it away.

If thats off only 1000watts, that much excursion, in that small a box, you are without a doubt in my mind clipping it!!!! Turn those gains down now, or enjoy your £250 paperweight!

There is no divide. Just engine off and HU on (so ignition on) then you will get 12v from the remote. When engine is running you'll get 14.4 from the remote cable (well you shoudl) All this does is click a relay within the amp. SO basically more than likely the amp is knackered if you have 14.4...

Remote cable on you HU playing up at a guess. Test it for voltage mate let us know.

No this is no boot space! Or this....... :rasp::rasp: That box is way way way way way too small for that sub! You'll need about 5 cubes minus displacements to get that sub to sing. Thats about 2 cubes there! Defiantly watch clip. Also if you get a D5000 take it easy on them, make sure...

What you going to be tuning it to then? Oh and you better not put it in a sealed box. Where abouts you based, i could help you with a box build.

Is that the 10" version? Mag looks small for the 12....