Search results

dunno mate, I thought it was heat proof, but may be wrong

No its not mate, its just an exhaust gasket, M8 bolts plus washers and some exhaust paste

Zymol carbon on all plastic trim, rubber seals & wiper blades Hyper dressing for arches Blackfire for tyres

Copper slip on the seat of the lambda stops this heppening in the future:)

Re: monaco red 04 plate 172 willenhall ..west mids As sgtbash says, Monaco is blue, Flame (172) and Capsicum (Trophy) is red dude

Cheers boys, will give them a call tomorrow

Where from fella?

Good choice on the prolines I would definately get a de-cat if you can be doing with the hassle come mot time. I have just fitted a decat to my 172 and already have one on the williams and hybrid.

How about these bottles for the 1L's? they are 950ml http://www.polishedbliss.co.uk/cgi-bin/sh000002.pl?REFPAGE=http%3a%2f%2fwww%2epolishedbliss%2eco%2euk%2facatalog%2fcar%2dcare%2dproducts%2dwash%2ehtml&WD=tardis&SHOP=%20&PN=autosmart%2dtardis%2dclean%2ehtml%23aAS1#aAS1 I'll happily take 2 of...

I'm in! 1. Michael172 - 1L 2. vala - 1L 3. xzibit - 500ml 4. stu-172 1L 5. The Detailer 2L 6. 1. 2. 3. 4. 5.

bump

see if you can get the UCH, key and ECU for £100, then you wont need to do any programming

get onto ebay and try the breakers, cit-ren etc You'll get the UCH and key's for about £75 ish I would imagine Contact this guy http://cgi.ebay.co.uk/RENAULT-CLIO-182-2005-55PLATE-BREAKING_W0QQitemZ260231099209QQihZ016QQcategoryZ10410QQssPageNameZWDVWQQrdZ1QQcmdZViewItem Hth

Hope that helps mate

Still looks good old chap Do you spray the whole thing in the bulk colour (red) and then hand paint the numbers silver?

Is it needed Ben or can I just rip it all out? Pt4 now has 2" of pipe with a 1" screw inside lol Does this look right to you Ben? The white, green, black and red fuse holders in the right places with the right fuses?

Mines £1500, but I cannot remember who that is with, the mrs deals with admin shizzle I'm insured on any car fully comp and 30 personal cars. I am 28 mind

No I dont think so mate, I had a look and should be able to see it without removing the plenum. It goes to a canister in the front drivers wheel arch, is this needed? I removed the acoustic valve from the other side and just put a screw in the pipe.

Yes mate, sat next to the car

Yeah speak to Middo, this looks quite good

Oh yeah, my bad:o I forgot the 172 cat goes right up to the engine almost, have fun Dav:clown:

Pt1 - Under plenum? Pt2 - Where is the acoustic valve that this fits into? Pt3 - CAS have one on the shelf for £21 Pt4 - As per Matt's post with a folded over piece of hose? Pt5 - I may of been a numpty! At the same time as fitting this engine I was also removing my Williams engine in...

Re: Few questions now engine is almost re-fitted *updated with pics* Pt1 Pt2 Pt3 Pt4 Pt5 Pt6 Sorted:approve: :D ;)

Its really easy mate, did mine on my own in 15mins. Use the renault jack to support one end while you fit the other Heres a picture of how the springs & washers etc fit

its a drying towel

Hmmmmmmmmmmmmm, I dont want or need to buy better ones, its only for my van Surely if the tweeter was knackered it would do it at all volume's and mainly while cranked up, not while on quiet. Will check all connections again, but they were all fine last time I had a quick look.

Adrian flux dont charge any extra for mods, they just wont pay out for them Had carbon bonnet, coilovers, exhaust and i/k on the 172 and no increase. Well only £20 admin fee to add them to my policy

2 pics sent ben, one of the Pt4 and one of Pt5, cheers fella Will pm you mm, will give you a discount for helping me out mate:)

I cant see photobucket pics at work Ben, there blocked :( Gearbox reverse sensor is on the shelf ...........£21 from CAS

I have a set of these cheap and cheerful comp's in the work van running off of my Kenwood amp. All is fine apart from one of the tweeters. On low volume it crackles, sort of sounds like it is under water and sometimes completely cuts out until I turn the volume up, then it suddenly just cuts...