Search results

DIY 30 mins tops 15 if you know what your doing, second hand one £40 I have a couple of spare at work if you need one I'll dig one out. Same as 172 by the way. or look on ebay...

Probably unrelated to previous problem you need to get it plugged in to diagnostic machine see what codes are showing most likely a lambda sensor playing up. Hope this helps.

I've got one I'll post tomorrow £10 inc postage.

I've had this before earth that bolts at the right hand side of the gearbox as your looking in the engine bay above passenger side driveshaft make sure you have tightened it as it causes all kinds of probs.

Looking to buy this car did it belong to anyone on here?

why?

http://cgi.ebay.co.uk/2002-RENAULT-RENAULTSPORT-CLIO-CUP-172-2-0-16V-BLUE-44K_W0QQitemZ360234824892QQcmdZViewItemQQptZAutomobiles_UK?hash=item53dfab34bc

More pics on request it states on the ad has anyone asked for some? I bet you don't just get car pics.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=300396437622&ssPageName=STRK:MESELX:IT I'll take £5000 no offers I'll also take a p/x

very big jubilee clip tighten it fit tensioner then remove it job done.

http://www.nesautos.co.uk/280199/used-cars.htm

13mm bolt below left of glovebox then pull the fuse box cover off a couple of torx screws a torch is a big help relays are attached to the rear of the uch try n do it without removing uch some nice upside down on your back not good. Have fun.

Massive insurance saving with Ibiza & loads of tuning options out their,cheaper timing belt changes by about £350.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=300382918258&ssPageName=STRK:MESE:IT One for you mechanics out their. £1500 to any cliosport member.

I've seen people knack clocks by removing bulbs just tape under the facia works a treat

Take the clocks out lift the edge of the facia black sparky tape under the facia if serv light also on you need to remove needles pm me I'll explain or ring me 07814953892

41 Leon Cupra R 265BHP

Running yet?

Check the uch fuses in the fuse box before you start throwing loads of money at it.

2 sensors plugged in? maf on left of manifold then a grey one on right of manifold.

Least its running good luck m8

Is the rubber seal fitted on the bottom of the upper inlet manifold egg shaped seal you'll need to lift it to check I'll bet it's fell out or the inlet is not sitting correctly on top of the engine.

under the small plastic cover on the bottom of box same square type sump plug as the engine.

Where is it being mot ed they'll fail it on something to make some cash keep us posted, I'm local & do a bit of work on renaults if your stuck.

Is it cranking yet?

Its often the tdc sensor plug at fault common problem. Good luck mate.

Well mate your wiring looks right all I noticed on your pic is the Black between the green & orange is sitting low as though its not plugged in fully. Couple of other things to check TDC sensor on top of gearbox although that wouldn't stop it turning over. These things hate poor batteries make...

I'm busy with a 172 at work at mo I'll check these against mine & let you know tomorrow.

No impact switch on Ph2s

The fuse holder right hand side of engine bay would have needed rejoining as it splits when fuses are removed load a photo as these could be slotted back together wrong need photos of the side so to check the colours of the fuse holders are in correct order memrory a double green a white and a...