Search results

It's quite common for abs sensors to pick up a load of crap when discs are changed, giving them off signals. Try cleaning off the ABS sensors, and checking the rings aren't cracked. And of you changed the rears, if they weren't genuine, check the abs ring is the same as the old one.

They're starting to crack oil scraper rings and blow turbos up, if you get one with a new turbo, make sure it doesn't smoke.

;) well I did the timing

I discovered last week that since clip has been updated, they've removed programming on the immobiliser for ph1's. You can buy the keys pre-programmed with new blade direct from Renault for ~£150

Need a bit more info (what's the engine in! Lol. As some are locked etc) but you'd be looking around £275 :)

1.9pd engines are epic. 2.0tdi's are utter shite.

One of my customers does. It should do!

WZL. It's my OH's.

I had a similar one that took over an hour of running to shut up. That engine had been stood a while.

Feel a little, but place the cap down, if it dances about the rings are away

How long had the engine been stood for before you bought it/ran it?

Chips turbo is running more than that, and regularly runs very sticky tyres

7 hours?! You're looking closer to 12 for a replacement. Also you'll be hard pushed to find a garage that Charges that little labour. I'm at £45/hr.

Cheaper to buy another engine.

If it's breathing then it's knackered rings. I took one apart today that the oil scraper ring just fell apart when I popped the piston out the bore.

Where did you buy the replacement? Did you replace the oil feed and return lines?

It could also be the sleeve on the driveshaft.

You can't use the cheaper one. It's about £126 now.

It will have a plaque on it if it's a milltek.

If you have a set then go for it ;)

Tony is on one of my favourite fast road setups. Induction kit, decat back exhaust, 197 cams, with ARP rod bolts. And mapped to suit. Standard pricing is £610 for an air con vehicle to have the belts replaced with dephaser. £100 to install and time the cams up properly, £250 to remap it...

Cams :)

FLOL!!!!!!!

Afaik the r26r still had a DMF? I thought it was a myth that it didn't?

That's natural flames/pops :)

DMF was the cause of the last one I had in.

Not too efficient. It's safe. The pops and bangs map allows over-run fuelling, but only around 22:1afr, then retards the ignition between 12 and 16 degrees atdc. Which inturn means that the mixture is still burning as it enters the exhaust stroke. Which then means those valve stems are being...

The standard fuelling strategy doesn't do what's required to pop and bang. They will when cold, but that's it.

Yes. The guy is off sick from falling off his chair laughing.

Boiling now mate? Lol.