Search results

Should be 8mm square drive sump plug adapter.

http://cgi.ebay.co.uk/RENAULT-CLIO-V6-AP-RACING-ALLOY-4-POT-CALIPERS-DISCS_W0QQitemZ230095839864QQihZ013QQcategoryZ10410QQrdZ1QQcmdZViewItem

MarkM is your system a single box, like the orbisound one?

Cough - http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&ih=001&sspagename=STRK%3AMESE%3AIT&viewitem=&item=110093765697&rd=1&rd=1 If this is the right side?

They are around £15 inc vat if i remember correctly. The filter is located under the drivers side slam panel (bottom of the windscreen), the panel is held on with 2/3 of those stupid plastic clips, once its off you will be able to see where the filter goes. Make sure its in the right way and...

Is it worth replacing the full assembly when fitting coilovers? Anybody know how much the are each from renault?

Its the sidewalls you have to worry about, have you ever seen a tyre under load going round a bend?????? Tyre gel/cleaner is dangerous full stop!!!!!

I am about to fit H&R coilovers to my 182 and was going to fit a full polybush set at the same time. I have now been hearing loads of bad press about them on the Clio's though, and was wondering what opinions are on these compared to standard renault ones.

Not got experiance, but have done lots of research in this area (wrote a 21,500 word project on it). Motec are widely regarded as the best, but not the easiest to use, but the advantage with the pectel is i believe it is compatable with some datalogging systems, depends what you are looking for...

Pretty poor power to start, how many miles had the car done?

Any other pics?

I spoke to them about these in early jan, thery had 5 units on test and where hoping that everything would be completed and them on sale mid Feb.

£1500 a set as well, just springs!!!!!!!

I can fit them no probs, just want them setting up properly once there on. Are you still doing them fmp? How much?

Do they come with the camber bolts or are they extra? Where is best to have them setup once fitted? Yozzasport/Mark Fish?

Im only putting 1 bucket in and leaving the rear seats in place, most of the time. I can use the standard mount for the rear belts for one side, just not sure about the other side. Does anybody only just have 1 bucket in? SM were does the outer belt mount to? I will be using a 4 point harness.

Anybody got any pics and details of were/how they mounted there harnesses to in the back of a 172/182?

Thats seriously nasty!!!!!! 182 looks good, is the footrest over the top of the standard one or replaced it alltogether?

This is as near as i have to a side shot, come and have a look tomorrow, i should have a tape-measure in my toolbox if you need it.#

Very close, with the boss on its closer than the standard wheel thats why i went flat and if i want it nearer i will get a spacer.

Its dirty now, had to go out up some muddy backroads, was fun, but in needs a clean again.

It deffinately comes with the horn!!!! No-probs chris, just come say hi.

Yep, well eibach pro's. H&R's by the end of the month, all going well. The its going on 15's.

Make sure its a large one, im from up north!!!!!

I'll have a pax lap in the cup then!!!!! Weather will be fine, snow will wont be anywhere near by then!!!!!!! I hope.

You there on saturday then?

I have actually cleaned several rally cars the day before they an event, none of them ever finished though!!!!!!!

Cleaner = Faster, its an unproven fact!!!!!!

If anybody mentions anything about tyre gel, im likly to kill them. The tyres are clean enough, im a driver (tyre cleaner makes tyres feel like there on ice!!!!!!!!!!!) 40k in 18months proves that and they ain't getting any cleaner.

Almost ready now!!!!!! Spent around 5hrs on it today (thats 11hrs in 3 days!!!) getting it ready for Saturday!!!!!!