Search results

6pm would be best, and is it still 7th Feb ye? 1) matt 2) the_prophet 3) cuppa 4) wiggle 5)^Jonff^ 6)pritchard182 7) Jay_low (James) my car will be ready so a good run is all it needs, Matt were in North Wales you from?

Right il try and remember this in deatils on how to remove the rear cards.. - Remove the rear seats completly - remove the bottom bolt that holds the seat belt in(bottom one its 17/19mm) - Next go and remove the top part of the driver's seat belt, the small handle you use to adjustthe belt...

Anyone have the part number for the bolt and nut for the wishbone/hub please, its the bolt that bolts underneath the hub and hold wishbone socket in place need them asap please, Thanks

Thats sounds ace, il keep a eye on this thread so i can remember about the event, il see you there scooty

Sounds good fella, il be around most probably as the track is only 20min from me, whats the chance of a free passenger ride ;)

Ace, il keep a eye out in our local paper will say on there hopefully, will do fella, if it has a big Scooty on the bonnet still then il spot you with no problem lol

^ ye the beam is strong enough to jack onto, just dont place stands there because you wont be able to drop the axle down then. just do as what me and DrRollo said and youl be grand.

no problems, Its preety straight forward tbh, once you do it you will kick yourself to see how easy it really is

LOL, you didnt tell me about this... explain, bit too far for me to attend :o

Yup, just take your time and you will be fine, you need to have access into the wheel arch so removing the arch liner is needed,

Re: 182 Cup Rally Project *UPDATES* I Shall be there to watch, What time does it start?

jack the car up and remove the passenger front wheel, remove arch liner and you will see the horn, look around there and there should be a orange connection thats for the fog lights,

Ye thats the correct bolt to remove to change the springs, its best if you remove both bolts and then rest one jack in the yellow point, so when it comes to jacking it back up you can make sure the springs sit properly.(bolting back is easier when you have the jack in the yellow spot, can...

Have you check if the connection for the loom is connected properly?

As you can see, car is running but has Stop / Serv / Airbag / Handbrake / ABS / Emmisions lights on.. Handbrake = no connector fitted airbag = under seat not connected emmisions = cat hasnt been sitting for the past 4months so needs a good run Serv= because of all the above.. But why is STOP...

^ just go on North west performance website and its about £10, dont go to renault as theyl just rip you off

Remove the rear passenger wheel and attack it from that position, much easier :)

Not sure if yours has it but on the hanger that goes through the mount there might be a bolt stopping you from removing the back box, you need to go under the car and look behind it, mine has and its a small 8-10mm one,

Any luck yet chrispy?

Is the cut out for a 3inch or 3.5?