Search results

Pass i'm not sure :sneaky:

Sounds like a dodgy sensor even though it's new.

You mention the EML flashing occasionally. If it's anything like the RS's, it's usually a fuel injector.

Is the boot closing tight on the latch? I know on the 172/182's you can adjust the latch. If you push on the boot when it's closed, does it move at all?

Maxton Design i'd guess. https://www.maxtondesign.co.uk/body-kits/renault/renault-clio/renault-clio-mk3-rs/renault-clio-mk3-rs-facelift/spoiler-cap-renault-clio-mk3-rs

This thread might help. https://cliosport.net/threads/hydraulic-clutch-kit-for-a-172.834346/

Pure Motorsport do a conversion kit.

You'd have been fine if the belts are being done soon. It was more the point of if it hadn't been done for ages and it needed some taking out, it may as well have been drained fully.

Mekanik

Mine still looks a bit golden after 5,000.

Yeah probably right, the pdf must be wrong.

Pass. Probably not different, just modified maybe.

Yeah 3 thou is 0.076? Thrust clearance on that list is wrong by the way, the upper limit should be 0.023mm not 0.23mm according to my Renault pdf.

0.040-0.075mm according to the specs i have. @NorthloopCup has the spec sheet i think. EDIT:

Would have been funny watching their faces seeing 8L of oil coming out of it 😂

Not too bad in the end then. When was the oil last changed, as it looks quite dark? I would have just dropped the lot and put fresh 5L in for the sake of £30.

Have you got a date for mapping?

Hope he sells it for that, obviously it'll be a baller/collector for that money. More of an £8-9k car for me that.

Missed that bit 😂 Yeah, should be working then :unsure:

Actually you're right, it's the same fuse as the stereo. Fuse F7 Pull the whole tray out and see if it's plugged in underneath.

I thought the 12v cig port had it's own fuse?

Never trust the digital readout, although mine is usually pretty accurate tbh. Probably got 7 or more litres in it I'm guessing 😅 Drain it out to the correct level and see how you get on. The exhaust is going to smoke for quite a while, you'll need to get it hot.

How much did you put in?

Only other way i can think of is with the Renault Clip software.

Mid torque is the best all rounder to go for.

There must be a way because on the dash test mode you can see MPH and KPH in the digital display. On newer Renaults, you use the up and down arrows on the right stalk, but the Clio doesn't have that :unsure:

Tbf you don't do track days. Different ballgame with the level of heat they see 😅

Is for seals, but tends to break down in sliders.

On track days I only take a 20L fuel can and usually fill up when it says 15-20L, so I usually just put it all in. Maybe test by putting a set amount in and see how long it takes to react.

All much of a muchness really. Go with whichever. Just make sure you use silicone grease on them and not copper grease or anything else.