Search results

You want 10.9 minimum

Never really updated this thread, but received the new subframe bolts and got them all bolted in. Then went around the whole front end with a fine tooth comb and made sure everything important was torqued and everything else was tight. Came across one bellhousing bolt that wasn't fully tight...

Noice, will get some ordered. I ran a sunstrip when I first got the 182, but when it was standard it looked w**k!

Link to sunstrip? looks good that mate.

That looks amazing for a spray job!

That's why i said it haha

Booked in at ATEC for Friday, usually gone to Bram but it's a bit of a long way and unsure on whether I can get the camber I want with bolts and slots alone so thought I'd give them a try. Very local too

Vband it

https://www.renaultgenuineparts.com/renault-8200268626-pipe-fuel/

What's the bonnet like on that 182? 😁

I shove about 80Nm on those bolts

They do fit, they just rub on themselves and fail prematurely.

One rib, i used jubilee clips to replace the cv clips too. Never had an issue.

That's the one, you'll want to get a cone too for fitting. You cut off a rib on the large side, maybe even take 2 off? I can't remember.

Pull the top of the door back slightly, get it by where the seal is, simples.

JR flexi boot. Cut off one of the ribs so it doesn't rub on itself and they're grand.

Coat hanger to the unlock button on the dash?

Wrapped bundle is for the red aftermarket alarm light in the centre console. The cable is a speaker connector, does your car have satnav? On satnav models they had a speaker above the cup holder in the middle so appears to be from that. Unsure on the other cut cables. Car may have had a nee...

Think hes still active on here @Mike@Rentech. Do you remember the car? I guess a number plate would help 😂

If its slipped then itll be bent valves unfortunately. Check out the alternator belt, and again...when were the belts done and by who?

Were the belts done recently and who by? Check the alternator belt is still in place and not wrapped itself around the cambelt!

Go for 12 mins toe out. That's standard and more than sufficient with about 1.30 camber

That's looking fantastic Paul, top work! How easy are the wipers to remove? I wouldn't mind cleaning mine up similar

Probably silver

Looks great but pleeeeease move the axle stand under the car. The front sills crumple for fun

Where are those mats from mate? Look fantastic

Anyone know the OD of the bottom rad hose? Wanting a new clip/clamp that bolts to the subframe. Presume the generic ebay ones will be fine?

Carbon canister?

Pop a multimeter on it to see if battery. If not, check pull on the battery with the multimeter and remove fuses until it goes away.

You sure that hasn't had a spraycan respray?