Search results

it's an injector.

air leak. spin the injector round, sounds like you've fitted wrong way possibly?

It certainly can.

Lambda can be out and not throw a light or log a code.

just rubber ring.

Perm 12v with ignition and pulsed earth on cranking. Decent code reader will tell you what cylinder is the issue.

Had plenty of crank sensors give misfire.

when you say the guy who set it up, what's been done/checked? just tracking up camber as well? not much left it can be so shouldn't be hard to find the issue. also have you changed bottom arms or just bushes and ball joints? also shouldn't be any play in damper shaft/top mount so that needs...

totally missed that bit...dozy t**t:tongueclosed:

rear dampers ok? bad ones can make the front feel awful sometimes.

Upper is different.

There's only one cts. Check the resistor for the fan speed or just unplug it and see how it goes.

get the mounts on and the brace will go in fine.

you can get a screw driver in that and lever it no problem.

pretentious, not racist. i stopped reading when i got to that bit.

Check the start of the stub axle to make sure it's OK. Seen them get squished when the spacer has been left of.

When and how much? Drop me pm if you would.

You 100% it's gone? Very very rare for bottom end problems.

no one noticed it's a 1.2 then?

Should of got it in from drivers wheel arch.

I've got 16-17-18 August as next time he's free although that was Monday so they're well of gone.

the wife's 172 has done touch over 200,000 now, uses a little bit of oil and gets it's head kicked in when i drive it...

how soon do you want it doing? i've got three dates from chris the other day to try and get a customers car over to him but haven't booked as yet.

don't ring chris at efi, he doesn't answer the phone!! drop him an email.

make sure it isn't ball joints before you change them.

all the ones i've done have needed doing.

cut a wedge out of it and get it welded back on but angled down slightly.

you can get the whole kit from euro for just under a fiver, have used loads of them and only ever had one where the bolts were to long.

need to mod top hose take off on the stat housing.

0136?