Search results

We'll all say yes because we like red tools 😂 Watch a few videos on comparisons and then make your own mind up, I'd say. Don't think I've seen the Milwaukee lose out to the DeWalt on any test I've watched tbh.

Yeah has to be an authorised seller to be able to register for the extended warranty.

I think it's just built up dirt.

Fuel tank is plastic, so that won't rust 😉

My short lance from Autobrite has been fine for 6 months. Looks a bit more solid than that one you have.

Can't see that working at all. Probably best to go for a BC coilover on the rear instead, which retains the standard shock and spring setup.

Yeah they're the main centre that TTi use.

Supercharged.

The ones that take up the slack of the main spring when on full droop 😉

Yeah CJ's are the main guys for Milwaukee repairs.

No don't think so.

1 like = 1 prayer

Fuckin' hell, good luck 😂

Not sure I like the idea of that really. It'll be a stud for a reason.

I believe it's an M8 stud.

Renault should have them but chances of them being a stocked item might be low. Could see if someone has a scrap head that they could remove one from.

Stud extractor and wind it out, then fit a new one. Weren't using 28ftlbs were you? 😅

Ahh yeah, it was 774 I was thinking of.

776 is right isn't it?

Locks up so you're unable to undo it unless you use a pair of grips. Fairly common, but keeping it lubed with WD-40 or light oil every now and again helps a lot.

Makes sense yeah. I was just thinking it would be money that could have been spent on other red tools 😂

SDS in M12 and M18 How come?

I've got this version with a 2.0ah on and it lasts about 6 hours on constant use.

Result!

That'll go for hours with a 4.0ah on it 😅

Yeah, should be able to tell by looking inside for the ball bearings like you say.

Keep an eye on the chuck thing on those gen 3 impact drivers boys. They're known for having a poor grip on the bits and the bits can just fall out. There's a gen 3.5 which fixes the issue. A new updated chuck isn't that expensive if yours does it.

Aye that sounds a bit rough like 🤔 Almost like the release bearing has come off the fork and catching the pressure plate.

What's not right with it mate?

Mustn't be an option on these then. I know you can get it for the Megane.