Search results

Where does it stand you up until this point, like including the cost of the car then stage 2 then stage 4?

Leave the TRE on the tie rod, angle grind the rod about half way. Put new tie rod in, measure the amount of remaining threads between the TRE lock nut and the last thread on the rod. Wind new TRE on until you reach the same said remaining threads. Hope that makes sense, it does to me 😂

That's the correct one.

Beyond my knowledge. Need someone with electrical fault finding skills.

Ahh right, must be a wiring issue then. Something got fried by the sounds of it.

I'm guessing the angle of which the IR light is hitting the plate is the problem. Mounting the camera lower down looking more straight on to the plate would probably help. Might be able to tweak a few things in the settings, things like wide dynamic range.

Probably blew the fuse.

This is the one I have http://m.ebay.co.uk/itm/401344032113?_mwBanner=1

Gav knows I'm joking. P.S. CSF boxing is in hand :wink:

Maybe the ones I've seen were mapped or something, but 'apparently' they were standard.

243! What's wrong with it. 😂 Every 250 I've seen at EFI has run around 270 standard.

Hoseclip will catch when the shaft spins won't it?

What other light is on with the SERV light?

What offset are the wheels for them to catch!

Even brand new, the sliders are s**t! Get some decent grease in them.

Sounds like the piston is sticking to me. Are your sliders working, can you pull the caliper back and forth by hand?

That's a bit s**t... Why's it doing that? IR light reflecting off it or is there another source of light nearby?

Looks like it yeah.

http://www.ebay.co.uk/itm/Genuine-Renault-Clio-2-0-16V-182-172-Sport-Alternator-7711134267-/271889562843?epid=652479106&hash=item3f4de17cdb:g:qUQAAOSwZd1VbuNX

Why would you want to do that, not really any advantage. The rear hubs are part of the rear beam so they aren't removable I think.

Renault Wolverhampton eBay page they're about £190 from memory.

Yeah I should have said, Valeo only for the alternator.

Nah, he can't even drive 😂

You don't know him lol.

Cheers.

A squirt of wd40 and wiggle the rail helps to get them out. Engine oil on the o-rings to get them back in.

If a mate wanted to come along with me in my car, how much is it for him on the gate on Friday for the weekend ticket? @Nik @Sunglasses_Ron

The injectors can be quite tight in the block, so a squirt of wd40 and wiggle the rail usually helps.

Actual physical fitment i'm not sure mate. But in terms of the lower amperage one then yeah that would work.

ET43 mate. The fronts have 5mm spacers on though so effectively ET38.