182 Cup Splitter

[Schweppy]

Just noticed that my 182s splitter is hanging a bit low in the middle section below the grill. It is pretty secure at either end. How can i fix/secure the middle section back on??? Is it staples or nails or something like that???

 

[Maz]

Self tappers iirc.

 

[Turner]

^^^As above self tapping screw

 

[Timmay]

yep self tappers

 

[Schweppy]

So can it been screwed in anywhere??? There is a chunk missing on the back of the splitter where it was last screwed in! Can I just make a new hole next to it??

 

[FlameR]

I wish the splitters were cheaper to replace. They break too easily!! Mine carbon fibre one has a chunk missing underneath, you can't really see it though!

 

[Maz]

There are cut outs in the splitters as standard, is that what your on about ?

 

[Schweppy]

Dont think so!!!?!?!? Theres a chunk missing in the rubber where the screw was before. So i guess i can just get another screw and screw it in a different place???

 

[Maz]

Oh right, mine has/had bits cut out of it as standard near the screw holes, can't see it being a problem as long as its not too close to the missing chunks.

 

[Karlos182]

They have little cut-out sections to make room for the bolts that hold the undertray on to the bumper. I always assumed the holes for the self tappers to hold the splitter on were pre-drilled into the splitter.

 

[Maz]

^ thats the ones I mean lol

 

[Turner]

Dont think so!!!?!?!? Theres a chunk missing in the rubber where the screw was before. So i guess i can just get another screw and screw it in a different place???

yes mate just pilot another hole were its a solid piece(like either side of the missing bit)and screw away:star:

 

[Schweppy]

Cheers guys