3D printing & scanning possibilities

[James363]

I have access to decent plastic 3D printing and high accuracy 3d laser scanning equipment, and I've recently done a few bits for car interiors, where the originals have broken, so it's been glued and then scanned. Made me wonder if there are any interior bits on the clios that anyone thinks are worth doing? I have a bed size of 300x300x400mm.
As a side note, I can do one offs from a sample, or if you are familiar with CAD and want a model printed I can handle this too.

 

[Krarl]

Centre caps for Turinis, OZ F1, headlight washer blanks, foglight cold air ducts for brakes, the end caps for 197/200 cup spoilers

I've thought about getting myself a printer and doing them myself in batches

 

[d19wood]

182 exhaust surrounds ?

 

[James363]

Those are some good shouts, thanks! I don't think exhaust surrounds would be so good, not sure how hot they get... But I'll definitely get some test pieces done and try them! Maybe on a mates car though haha

 

[Alastair.]

If you can make up some o.z f1 wheel center caps you’ll sell loads. The file is on here somewhere.

I would buy a set