3M-DiNoc Carbon Fibre Vinyl Wrap

[Gingbeard]

I've been looking around the forums at the project pages, I think that the DiNoc look for interior strips like in the thread HERE. Does anyone know roughly the dimensions needed for the strip and heater surround (as in the pics)?

I also found this on Fleabay (Here) is it just me or does this seem too cheap?

How easy of a job is it to do?

 

[syko6288]

I got a 1220mmx600mm and did

Dimonds
Bullets
Dash strips
Gear insert
Steering insert
Hazzard panel
Interior light
Exhaust surrounds


And got plenty spare

I got the sheet from carbon mods for £30

 

[mr.valver]

I've just bought 300x1200 off fleabay and done:

Bullets
Front\Rear diamonds
all 4 wheels diamonds
2 fog light covers

still got over 1/2 left.

 

[syko6288]

Post pic of fogs and wheel dimonds as there next on my list

 

[sofaboy]

Hiyer dude just read that PM so thought id jump in here, the strips in my old car will be a different dimension to yours with my oldun being a mk3, however its pretty easy to do, where abouts are you?

 

[Gingbeard]

Hiyer dude just read that PM so thought id jump in here, the strips in my old car will be a different dimension to yours with my oldun being a mk3, however its pretty easy to do, where abouts are you?

Sudbury, Suffolk.

How easy of a job is it to do? Does the 3M eventually start to peel etc?

 

[syko6288]

Wraping the bits mainly is patience's a hair dryer and old top up card and work i on and stretch it around the edges to avoid the crease's and ive had mine on for month's and there still fine
Am im presses with the front dimond no marks or peeling