A pillar / headlining question

[maynard]

About to remove the A pillar and headlining, quick question, does anyone know on the A pillar if the sensor for the alarm comes apart easily at all and if so how?

Also for the interior light, what wires/connections are under there? Is there enough play on the loom to be able to tidy away some where? Same goes for the aerial?

 

[Curtis!]

Pull the alarm sensor out of the bracket and they'll more than likely be a screw under there.

Pull the door seal off and they're one clip acouple of inches down from the top, pull up and out done.

Never had the headlining out so don't know the other two sorry!

 

[SimonR.]

In the interior light there is a 3 wire with a clip connector. Loads of room in there

 

[maynard]

In the interior light there is a 3 wire with a clip connector. Loads of room in there

How does the interior light come off, is it seperate to the headlining or all in one?

 

[SimonR.]

Pulls off then you unclip the wire from the light console part

 

[maynard]

Nice one Simon

Any clue on the aerial - is there plenty of wire to dangle it out of the way or is it clipped into the roof?

 

[SimonR.]

Still got my standard in so can't help you there, not fiddled around with it yet

 

[maynard]

No worries, I'll just go from there when I pull the headlining off and see what happens!