Air conditioning seals - replacing

[oreA]

I have a leaky air con system & so I have bought a seal kit - a bunch of brown coloured o-rings - can anyone offer advice on fitting these? Do I just make my way round each and every join and replace the seal? I can't find a guide anywhere, and it seems like a daunting task!

Any help greatly appreciated!

 

[hipwell]

If it's as simple as removing the air con system was it won't be difficult. There aren't many joins anyway so I think your approach will be fine

 

[oreA]

Thank you, that’s reassuring. Perhaps my kit comes with surplus o-rings ‘cos there’s about 20 of them ?!

 

[Coops Mk1]

Two on pump, two on rad, two on condensor (I think it's completely separately piped even though attached to rad) two to bulkhead. Think that's it

 

[oreA]

Not too bad then, hope there’s suitable rings in here ^

 

[oreA]

Two on pump, two on rad, two on condensor (I think it's completely separately piped even though attached to rad) two to bulkhead. Think that's it

I started this the other day, and just out of interest there are actually 4 at the bulkhead - there’s some kind of metal block (pressure relief valve or summat perhaps?) with two pipes in and two out, each with an o-ring. This is where I had initially spotted leakiness, so have only done these so far. I might go get it pressure checked cos I can’t be bothered doing all the others .

 

[gambit]

Thread bump! Is there a diagram of all the seals and where they go on the system?