ph1 172 Black
Nearside wheel has been rubbing previously by the look of it. There has been a new caliper fitted so I don't know if the wheel has had a knock but the wheel looks original and unbuckled.
Anyway the gap on the otherside is small but worse on the nearside. Could it be a poor camber setting? Was hoping to lower bit I think this could worsen the gap. How do I go about get this checked without paying Ren a fortune.
I know you can buy wheel spacers, would that help? It's not catching at the min cause rolls well without engine running with no rubbing sound and it would wear the tyre if anything was catching. Should I be looking a camber alignment check and if so were would I get this done!
Nothing could be catching at the min since I got 139 out of it on way to PVS. Just worries me and handling over bumps can be a little shaky but don't know if that normal?!?
Anyway the gap on the otherside is small but worse on the nearside. Could it be a poor camber setting? Was hoping to lower bit I think this could worsen the gap. How do I go about get this checked without paying Ren a fortune.
I know you can buy wheel spacers, would that help? It's not catching at the min cause rolls well without engine running with no rubbing sound and it would wear the tyre if anything was catching. Should I be looking a camber alignment check and if so were would I get this done!
Nothing could be catching at the min since I got 139 out of it on way to PVS. Just worries me and handling over bumps can be a little shaky but don't know if that normal?!?
