Bc racing too low at rear

[Ex-User (107751)]

Using the included 10mm spacer for the rear springs, I still don't have any arch gap at the rear!
I've set the front about 20cm lower than the rear, and I get about 5 cm arch gap at the front , looking really bad and assymetrical.
I don't want the front any lower than it is currently, to not hurt the roll center.
Anything I can do to raise the rear ?

 

[DCELEC 182]

Think you might need to look at whether or not you've fitted everything correctly.....I have no problem with the rear being low on mine with the BC kit fitted.

 

[Ex-User (107751)]

Not sure what could have been done wrong ?
Rubber mount thing on buttom,
On top there's the Isolator spacer, 10mm spacer, piece that goes into the 10mm spacer, and top "hat".

 

[BlackGoldMatt]

I have a set of rear spring adjusters if of interest? Taken out from my Bilstein B14's as the rear was too high!

 

[Ex-User (107751)]

Would love those but I'm outside Europe.
Can anyone actually confirm the rear height adjusters from the b14 will match ?