Bearing press kit

[dann2707]

Hi ,

Does anyone have any recommendations on a bearing press kit, I need a s**t load of inserts at various diameters.

I always retain old bearing races and using sockets is always hit and miss whether I have the correct size.

I borrowed a set from a mate at work to press in some powerflex bushes which was perfect, I then checked to see how much it was and it was £600 or so :O

Don't want to be paying that much ideally!!

Thanks

 

[dann2707]

Maybe something like this??

https://www.amazon.co.uk/dp/B01K9XJXUK/?tag=cliospnet01-21

 

[JamesBryan]

Get @Louis to turn you a load of diameters on a lathe from off cuts of round bar.

 

[Louis]

3d print them

 

[leeds2592]

3d print them

Don't encourage him. He'd 3d print a house if he could!

 

[JamesBryan]

The kit you linked looks pretty comprehensive.

Saw this one which is a bit cheaper but doesn't cover the range that your link had

Silverline Bearing Race & Seal Driver Kit 10pce 40 - 81mm

Aluminium bearing race and seal drivers. For straight installation of bearing race without damaging bearing or axle housing. Fits most common bearing race sizes. Includes driver sizes: 40, 44, 50, ....

www.mad4tools.com

 

[Mavez]

I bought these two on ebay about £60. So far been successful beating out an outer race from a front hub and a bearing from a rear drum.

 

[Robbie Corbett]

I just use the cups out of this set which works well. Get to use it off the press too. £75 but I'm sure you can get them loads cheaper

 

[dann2707]

Cheers mate. Went for this in the end and it's fantastic. Really decent for the price (£99)!

Used it loads already, the walls are 5mm thick so pretty strong

 

[Robbie Corbett]

Good man. Looks like a nice set. They are pretty handy for doing rear arm bushes on loads of cars because you don't have to remove everything and carry to the press.