Breaking it in

[ya53lhd_MATT]

What's the general consensus for running a F4R in? Guessing it varies with what you replace?

My replacements; Big end bearings, APR's, Rings, Valves, Oil Pump, Water Pump, Cambelt Kit, All Gaskets + Seal

Thanks in advance, matt

 

[theduck]

Warm it up fully the drive as hard as you like.

 

[ya53lhd_MATT]

Don't even want to say this, but really? lol

 

[The Chubby Pirate]

Yep, temp up - kick its hole in.

 

[Fred@BTM]

rev limiter from cold (in gear under load) 20min done

 

[ya53lhd_MATT]

Just tried that from cold... bouncing off the limiter in 1st gear! It didn't last 20 minutes though? It didn't come up to temp either?

 

[ya53lhd_MATT]

It wont start now either?

 

[.Stevo.C.]

Just tried that from cold... bouncing off the limiter in 1st gear! It didn't last 20 minutes though? It didn't come up to temp either?

ffs!

 

[ya53lhd_MATT]

I want a refund Cs.net!!!

 

[Fred@BTM]

good luck!

 

[ya53lhd_MATT]

I was kidding But seriously, what would you say is safe?

 

[Fred@BTM]

warm it up and give it abuse upto 75% rpm (i'm being serious this time, i was last time, but that more for race engines)

 

[Cupman29]

Thought you meant a new girlfriend when you mention breaking it in.

 

[Addicted]

Thought you meant a new girlfriend when you mention breaking it in.

Same applies doesn't it? Warm it up and give it abuse!

 

[Cupman29]

Same applies doesn't it? Warm it up and give it abuse!

Very true! :lolup: