BTB catback dropped in middle. mounting help please

[brohoward71]

Hi Guys
This is my first "HELP ME" post
so I bought my 182 with a BTB catback fitted and all was good.
But now its blowing from the joint to the cat. Looking underneath its definitely hanging low at that point.
I have only stuck my head under with it up on a jack at the moment but im a bit baffled as to where the mounting points are.
There are obviously the two at the back (which im replacing coz they are knackered) then moving forward I see one just ahead of the rear wheels .
from there on I dont see anymore mounts. The centre section just joins the cat and there isnt a visible mount around this point.
Is there supposed to be ? it would seem this is the point where a mount is needed most.
Any help will be appreciated and also any ides for improving mounting points / mounts etc
thanks guys

 

[Budgie]

Nope, no mount there. As you've said, you have the two rear box mounts, then one halfway up the car for the centre section.

 

[brohoward71]

ok thanks.
so is it common to have some droop in the centre ?
Is it just a case of dissasemble and reassemble

 

[Faboka]

Replace the cat to center section mount. I'd also replace the center exhaust mount/hanger.

Only use Reno parts.

 

[brohoward71]

Replace the cat to center section mount. I'd also replace the center exhaust mount/hanger.

Only use Reno parts.

Is this the clamp joining the two pieces together ? does it have an internal flange ?

 

[Faboka]

Joins the 2 together. No flange.