changed steering wheel and omp boss and now traction light on when turning?

[jamesv6]

Hi all i changed my steering wheel to a deep dish and omp boss on my 182, when i turn the car on no faults on dash as i also put resistors in the airbag plugs to cancell the airbag light, drive straight and no fault, as soon as i turn the wheel it chucks up the traction control and serv light, turn the car off and fault goes till i turn the wheel again while going forward, all i did was undo the t50 torx and slide the boss on and did up, does anyone no where the steering sensor is on the wheel shaft? or has anyone experienced this before? cheers.

 

[jamesv6]

ok ive just read about the steering rotary sensor, looks like i may have changed the position of it while bolting the boss on, hense the ecu is confused .