modded 04 Clio 1.2
i have just bought all the bits i need to put a comp in my clio, however, i need a wiring diagram for my clio (2004 1.2 expression) to make best use from the setup. please if someone has access to good quality diagrams please pm/email me d.hall40 at ntlworld.com
this is a long shot but does anyone have any ideas whether i could use the stalk controls to change tracks.
the setup up im going for is:
pc:
jetway board w/ via c7 mini itx mobo (low power usage, imported from usa)
1 gig ddr2 (ultra low power ram)
160 gig sata seagate 7200rpm (low power, high shock resistance)
m2-atx 160W intelligent dc-dc psu
Voom pc car enclosure
4 port mini usb hub (to be molded into the dash at a laterstage)
laptop dvd writer (as above)
7" lilliput touchscreen(as above)
future upgrades:
3 in 1 aerial (gps, radio/tv, wireless)
gps reciever (usb)
tv card w/ remote (usb)
2 headrest monitors (incluiding switches and amps)
OBD-2 iso connector + software (onboard diags/sensor readings)
parallel actuators (to control car solenoids ie door locks, electric windows, neons etc)
ice:
cwappy sony HU (once pc all setup with radio/tv will do away with this)
2 x 12" alphasonik 900W rms subs
2 x 10" sony 1000W max subs
1 x boss blx 4000W 2ch amp
future upgrades:
full fibreglass boot/door card/rear quarter panel install
8" subs + components in custom door cards
components in rear seats
however many amps and batteries need for good quality sound
alternator isolator to charge batteries
this is a long shot but does anyone have any ideas whether i could use the stalk controls to change tracks.
the setup up im going for is:
pc:
jetway board w/ via c7 mini itx mobo (low power usage, imported from usa)
1 gig ddr2 (ultra low power ram)
160 gig sata seagate 7200rpm (low power, high shock resistance)
m2-atx 160W intelligent dc-dc psu
Voom pc car enclosure
4 port mini usb hub (to be molded into the dash at a laterstage)
laptop dvd writer (as above)
7" lilliput touchscreen(as above)
future upgrades:
3 in 1 aerial (gps, radio/tv, wireless)
gps reciever (usb)
tv card w/ remote (usb)
2 headrest monitors (incluiding switches and amps)
OBD-2 iso connector + software (onboard diags/sensor readings)
parallel actuators (to control car solenoids ie door locks, electric windows, neons etc)
ice:
cwappy sony HU (once pc all setup with radio/tv will do away with this)
2 x 12" alphasonik 900W rms subs
2 x 10" sony 1000W max subs
1 x boss blx 4000W 2ch amp
future upgrades:
full fibreglass boot/door card/rear quarter panel install
8" subs + components in custom door cards
components in rear seats
however many amps and batteries need for good quality sound
alternator isolator to charge batteries