ClioSport.net
Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
-
When you purchase through links on our site, we may earn an affiliate commission. Read more here.
fabia splitter fitting?
- Thread starter brewer07
- Start date
mk2 ph3 1.2
Use a piece of masking tape to get the centre line of your bumper (put vertically from front diamond) put a self tapping screw in the centre of the new splitter, jack the car up (easier if you have the back of your car on axle stands or a step/curb) and screw the splitter into the bumper dead centre. Screw more into the splitter outwards from the middle. Cut off the excess from each side with a craft/Stanley knife. Lightly sand the edges with some sandpaper.
Sunglasses_Ron
ClioSport Admin
Piece of piss mate. Get someone to help you line it up and then just screw it onto the bumper with self tapping screws. It will be a bit too long at both ends so just cut the ends of with a Stanley knife.
Done three fairly easily, much easier if you can get the car higher, maybe on two bricks. I started by evenly spacing the screws already in the splitter so they were just piercing through and started from the middle.
It will seem like its taking forever, and your hand will ache but its worth it in the end.
It will seem like its taking forever, and your hand will ache but its worth it in the end.
