fabia splitter fitting?

[brewer07]

i have recently bought a fabia splitter for my 172 cup and was wondering the best way to fit it

 

[RobbHughes]

Use a piece of masking tape to get the centre line of your bumper (put vertically from front diamond) put a self tapping screw in the centre of the new splitter, jack the car up (easier if you have the back of your car on axle stands or a step/curb) and screw the splitter into the bumper dead centre. Screw more into the splitter outwards from the middle. Cut off the excess from each side with a craft/Stanley knife. Lightly sand the edges with some sandpaper.

 

[Sunglasses_Ron]

Piece of piss mate. Get someone to help you line it up and then just screw it onto the bumper with self tapping screws. It will be a bit too long at both ends so just cut the ends of with a Stanley knife.

 

[Adam D]

Done three fairly easily, much easier if you can get the car higher, maybe on two bricks. I started by evenly spacing the screws already in the splitter so they were just piercing through and started from the middle.

It will seem like its taking forever, and your hand will ache but its worth it in the end.

 

[brewer07]

cheers guys will get it done once this snow clears away