Fitting rear 182 shock, help please

[chris182cup]

Can I just tighten them up normally ? Without the rite torque?

I'm going to be brave try fit it myself

 

[blackpanther]

really easy mate, bolt them in at the top 1st. I did mine many times, just tighen them up tight and they will be fine.

 

[chris182cup]

Thanks

 

[Jonny1*2]

as said, really easy. Jack up the rear, put axle stands on both rear jacking points. Put the jack on the middle of the rear beam (just to support it when you remove the shocks, although if you do them one at a time it might not be too bad). Loosen top first, then do the 18mm rear bolt. Then replace. Make sure they are nice and tight. I use a breaker bar to tighten my bottom bolts.

 

[DrewG]

^^ Nice one gents